PMi3D racing intake manifold kit R125 - MT125 V2 - XSR125

The PMi3D Intake Racing Manifold Kit consists of a sleeve, a connector and a rigid tulip for the original Yamaha 125 VVA Euro5 air box.
This Racing intake kit does not exist on any other site and anywhere else and has been the subject of a long R&D process, with Fast125, in order to find the best material that can be printed while resisting gasoline mist !
Many tests were carried out before being able to offer it to you and as it is the very 1st Racing Tubing that exists for VVA Euro5 engines with an original air box, Exceptionally PMi3D guarantees this product for 12 months which habit does not do this on competition parts!

The whole kit is adaptable with 34 or 36 SCK throttle bodies and others..., allowing your engine to express all its rage on your Small Block or Big Block :o)

PMi3D being a very young company, do not hesitate to leave a comment on this Racing Admission Kit!

Here are some technical tips:
- You must eliminate the hooks of the old original tubing in the air box (see photo circled in red) to allow the intake tulip to pass.
- Your injector must be adapted to your cubic capacity.
- A programmable ECU is recommended.
- You can put some black sealant in the stop fixing groove of the sleeve | | air box, in case the hole is damaged or a mini air intake!
- Works with the original resonator.
- Not sold with a 60mm clamp!
- Check that the tightening of the components is correct after 150 kilometres.
- Do not use Super-Glue or Loctite type glue on the thread.
- To facilitate assembly in cold weather of the coupling sleeve, use a hot air gun for 10 to 20 seconds, which will soften the material a little.

To see if the part is compatible, please look at the vehicle table below!

Terms and conditions*
Pay in  with a Paypal account
Satisfied or your money back for 30 days 
DHL Express delivery ⛟ | Product return ♽